find ip address and port for teamviewer wake on lan

You can turn on a sleeping or powered-off computer using TeamViewer’s Wake-on-LAN feature.

Verify that the remote system powered on correctly.

On a remote Windows Server 2008* system that is on the same subnet of the system to Wake Up, run a WOL utility.

Make a note of the MAC address, IP address, and Subnet Mask of the Network Adapter for which WOL was enabled.

If you have Allow PCI to wake up the system setting available in BIOS be sure to enable it as well. Now locate Deep Sleep control and set it to Disabled. Once you enter BIOS, you need to find and set Wake on LAN to Enabled. To fix the problem, you need to enter BIOS and change a couple of settings.

Click the UEFI Firmware Settings option.Under the “Advanced startup” section, click the Restart now button.To enable Wake on LAN on the device firmware, use these steps: The Wake-on-LAN packet must be forwarded to every device running behind your router, and a device will only wake up if the information in the WoL packet matches it. You’ll need to forward a UDP port to all IP addresses behind your router-you can’t just forward to a specific IP address. Do you need port forwarding for Wake on LAN?

Find ip address and port for teamviewer wake on lan